To do this, shutdown your NIC, activate the monitor mode and then enable the card again. Not all network card can be configured in monitor mode. This mode allows the NIC to capture all Wi-Fi packets present in the air. The first thing to do is to configure the network card used to launch the attack in “ monitor” mode. Step 1 – Configure attacker’s WLAN network card Kismet is useful to find information about current broadcasted SSIDs in the area and aircrack-ng is a set of tools that we need to launch the attack. On my Ubuntu I have to install them using this command: sudo apt install kismet aircrack-ng If you use Kali Linux, these tools are directly available. Step 0 – Install hacking toolsįor this attack, I only use “ kismet” and “ aircrack-ng“. Using my favorite Linux distro, I will sniff the Wireless networks to find all needed information to run this attack. The victim, my phone NEXUS 4 running android, is connected on this SSID and can navigate to Internet without problem. Demonstrationįor this demonstration, I created a dummy SSID named “WIFI_HACKING” which is broadcasted by my FortiWIFI 30E at home. Because a wireless client is identified by its MAC address, an attacker can send deauthentication request by spoofing the source MAC address by using this of the victim. The Wi-Fi protocol (IEEE 802.11) contains a mechanism that allows a wireless client to send deauthentication frame. This attack targets communications between a client and the access-point on which it is connected.
#Get wifi client mac for airelay how to#
In this post I will explain step by step how to perform a small DoS attack on a specific Wireless client using the concept of deauthentication attack.
0 kommentar(er)
